Recent Post

RANGKAIAN INVERTER 12 VOLT UNTUK SOLDER



RANGKAIAN INVERTER 12 VOLT UNTUK SOLDER

Here is a simple 12 V inverter for application a baby soldering adamant (25W, 35W, etc) in the absence of mains supply. It uses eight transistors and a few resistors and capacitors. Transistors T1 and T2 (each BC547) anatomy an astable multivibrator that produces 50Hz signal. The commutual outputs from the collectors of transistors T1 and T2 are fed to pnp Darlington disciplinarian stages formed by transistor pairs T3-T5 and T4-T6 (utilising BC558 and BD140). The outputs from the drivers are fed to transistors T7 and T8 (each 2N3055) affiliated for push-pull operation. Use acceptable heat-sinks for transistors T5 through T8.

230V AC primary to 12V-0-12V, 4.5A accessory agent (X1) is used. The centre-tapped terminal of the accessory of the agent is affiliated to the array (12V, 7Ah), while the added two terminals of the accessory are affiliated to the collectors of ability transistors T7 and T8, respectively.

When you ability the ambit application about-face S1, agent X1 produces 230V AC at its primary terminal. This voltage can be acclimated to calefaction your soldering iron. Assemble the ambit on a accepted purpose PCB and abode in a acceptable cabinet. Connect the array and agent with acceptable current-carrying wires. On the advanced console of the box, fit ability about-face S1 and a 3-pin atrium for abutting the soldering iron.

Stumble This Fav This With Technorati Add To Del.icio.us Digg This Add To Reddit Add To Facebook Add To Yahoo